Ntdk20 Ssc Card Installation On Ip Expansion Cabinets And Chassis - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

Installing Small System Controller and Fiber Receiver cards
Figure 86
Glass fiber-optic cable connection on dual-port daughterboard
SSC cable router
NTDK20 SSC card installation on IP expansion cabinets
and chassis
Software daughterboard and security device
Glass fiber-optic cable connections
IP expansion cabinets or chassis require an NTDK20 SSC card equipped with
an IP daughterboard. The minimum vintage SSC card for an expansion
cabinet is NTDK20CA; the minimum vintage for an expansion chassis is
NTDK20EA. Option 11C Chassis requires minimum NTDK20EA in both
main and expansion chassis. This section describes the steps necessary to
install the SSC cards, daughterboards, cables, and any other components that
are required on the SSC card.
Refer to Procedure 19 on
and security device".
page 191, "Installing the Software Daughterboard
Small System
Page 211 of 562
Installation and Configuration