Nortel Meridian 1 Succession 1000M Installation And Configuration Manual page 108

Page 108 of 562
553-3011-210 Standard 1.00
Installing the Chassis system
5 If your Small System requires earthquake bracing, refer to "Bracing
against earthquakes" on
For your system to be braced against earthquakes, you must install the
chassis on a wall in a vertical position.
6 Locate the box containing the Small System equipment.
7 Install the chassis. See "Mounting the chassis" on
of the following procedures, depending on the position in which you will
install the chassis:
— Procedure 8: "Installing the chassis in a 19-inch rack/equipment
cabinet" on
— Procedure 9: "Installing the chassis on a wall in a vertical position"
on page 135
— Procedure 10: "Installing the chassis on a wall in a horizontal
position" on
8 Install the chassis expander. See "Connecting the chassis expander to the
chassis" on page
chassis.
Install the chassis expander the same way as the chassis. Refer to
Procedure 11: "Adding a chassis expander" on
describes how to connect the chassis to the chassis expander by using the
two NTDK95 CE-MUX/DS-30X cables.
9 Install the chassis ground wire for the chassis and chassis expander at this
site. See "Installing the system ground" on
Refer to one of the following procedures:
— Procedure 12: "Grounding the cabinets or chassis" on
— Procedure 13: "Earthing the cabinets or chassis (UK)" on
To ground multiple pieces of equipment in a rack/cabinet when one or
more pieces of equipment does not have a grounding lug, see "Multiple
pieces of equipment in an equipment rack/cabinet" on
October 2003
page 79.
page 129
page 141
145. You can skip this step if your system only has one
page 125. Refer to one
page 146. This procedure
page 149.
page 151
page 156
page 156.