Changing The Default Numbering Plan; Extensions Assigned Differ From The Default Numbering Plan; Changing The First Number In The Numbering Plan - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

Changing the default numbering plan

Extensions assigned differ from the default numbering plan

Changing the first number in the numbering plan

You may need to change the default numbering plan in order to improve
performance or to remove numbering plan conflicts. Refer to Tables 81
through 87 on pages 411 to 419
assignments for Cabinet and Chassis systems.
Compare the first digits assigned to this system with the default numbering
plan as shown in Table 73 on
• If the first digit is in the unused range, change the first number in the
default numbering plan. To do this, follow the instructions in "Changing
the first number in the numbering plan" on
• If the first digit is being used by Meridian Mail, trunk routes, or other
data, you must remove these interferences. Follow the instructions found
in "Removing numbering plan conflicts" on
To change the first number in the numbering plan perform the following
procedure.
Procedure 67
Changing the first number in the numbering plan
1 Pick up the handset of the administration telephone.
2 Enter the administration Flexible Feature Code. (For some countries, this
value is listed in the Table 88 on
3 Enter the administration telephone password. (For some countries, this
value is listed in Table 72 on
4 You hear special dial tone and the prompt "TASK?" appears on the top
line of the character display.
5 Press the asterisk (*) three times.
The second line of the character display reads "4 INSTALLATION
OPTIONS".
6 Select "4 INSTALLATION OPTIONS" by entering the number "4".
Changing preprogrammed data
for a full listing of the default DN
page 402.
page 420.)
page 401.)
Small System
Page 471 of 562
page 471.
page 475.
Installation and Configuration