Activating A Customized Model Without A Character Display - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

Page 356 of 562

Activating a customized model without a character display

553-3011-210 Standard 1.00
Connecting the telephones
If the extension number is not available for use, you hear overflow tone.
The character display shows "ERROR, EXTENSION?" and you must
repeat this step.
Note: If other keys require secondary extension numbers, you are
prompted until you enter all of the required extension numbers for the
model. These extension numbers cannot be defaulted. The text display
prompting for further extension numbers is "KEY kk EXT?" where "kk"
represents the key number requiring the extension number. Each prompt
for another extension number is accompanied by special dial tone. When
you are programming an extension number, the lamp associated with that
number on the telephone is lit.
4 Hang up the telephone handset.
After approximately 10 seconds, the telephone is configured.
Note: If you replace the handset before you complete the prompt
sequence, the installation automatically fails. This can be useful if you
make an error and want to restart the procedure.
Procedure 61
Activating a customized telephone
1 Plug the telephone set into the jack and wait 20 seconds before picking
up the handset. If you do not receive dial tone, replace the handset and
wait another 10 seconds before going off-hook again. Repeat this
procedure until dial tone is received.
Note: The 20 second time interval is required for the system to determine
whether the set is new or if it is being relocated using the Modular
Telephone Relocation feature.
2 Press the digits associated with the customized model and press the
pound key (#).
Dial tone disappears after the first digit is pressed, and you hear three
beeps followed by continuous dial tone (special dial tone) after you press
the pound key.
3 Enter the customized extension number and press the pound key.
October 2003
End of Procedure