Nortel Meridian 1 Succession 1000M Installation And Configuration Manual page 204

Page 204 of 562
Figure 81
NTDK22 single-port fiber Expansion Daughterboard
553-3011-210 Standard 1.00
Installing Small System Controller and Fiber Receiver cards
Procedure 23
Installing the dual-port fiber Expansion Daughterboards on the SSC
card of the main cabinet or chassis
1 Put on the antistatic wrist strap.
2 Place the SSC card on a clean flat surface.
3 Install the fiber daughterboard for expansion cabinets or chassis "1" and
"3" on the connector as shown in Figure 83 on
connector).
4 Install the fiber daughterboard for expansion cabinets or chassis "2" and
"4" on the connector as shown in Figure 83 on
connector).
5 Connect the faceplate LED to the 3-pin header on the daughterboard. See
Figure 83 on page
6 Press firmly on the standoffs to ensure that the cards are secured to the
SSC.
October 2003
206.
page 206 (the upper
page 206 (the lower