Nortel Meridian 1 Succession 1000M Installation And Configuration Manual page 210

Page 210 of 562
553-3011-210 Standard 1.00
Installing Small System Controller and Fiber Receiver cards
Procedure 25
Installing glass fiber-optic cable
1 Put on the antistatic wrist strap.
2 Place the SSC card on a clean flat surface.
3 Remove the protective plugs from one connector on the Fiber
Daughterboard.
4 Remove the protective cap from the corresponding plug (Tx or Rx) on the
glass fiber-optic cable.
5 Insert the plug in its designated connector on the daughterboard. Once
inserted, lock the connector in place by turning it a half turn clockwise.
Refer to Figure 86 on
6 Repeat the steps above for the remaining connector and plug.
7 Route the fiber cables through the SSC cable router on the SSC card.
Refer to Figure 86 on
8 Insert the SSC card into slot 0 of the main cabinet or chassis. Lock card
into faceplate latches.
9 Route the cables through the SSC Cable Routing Guide under the main
cabinet as shown in Figure 78 on
October 2003
page 211.
page 211 for location of the cable router.
page 199.
End of Procedure