Introduction - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

Page 470 of 562

Introduction

553-3011-210 Standard 1.00
Changing preprogrammed data
Printing model information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Analog telephones . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Digital telephones . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Removing model telephones. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Creating model trunks and changing route access codes . . . . . . . . . . .
Creating model trunks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Modifying model trunks. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Removing model trunks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Printing model information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Changing a route access code . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The preprogrammed data on the Small System can provide an effective
starting point for programming the system's telephone and trunking
information.
This chapter shows how to change the default Small System numbering plan.
You may want to change the numbering plan for one or more of the following
reasons:
• to change the first number in the numbering plan
• to shift the start of the numbering plan to another card slot
• because the default numbering plan interferes with the system data
This section describes how to make changes to the default numbering plan.
This section also provides information about modifying model telephone and
trunk programming stored in the system's preprogrammed data.
October 2003
484
484
484
485
485
486
487
487
488
488