Fiber Receiver Card Installation On Expansion Cabinets And Chassis - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

Installing Small System Controller and Fiber Receiver cards
Fiber Receiver card installation on expansion cabinets and
chassis
Fiber expansion cabinets or chassis require an NTDK23 Fiber Receiver card.
This section describes the steps necessary to connect the cables and install the
Fiber Receiver card.
Procedure 26
Installing the Fiber Receiver card
1 Put on the antistatic wrist strap.
2 Place the Fiber Receiver card on a clean flat surface.
3 Remove the protective plugs from the connectors on the Fiber Receiver
card.
4 Install the fiber-optic cable:
• To install the 10 m plastic fiber-optic cable, refer to Figure 87 on
page 214.
• To install glass fiber-optic cable, refer to Figure 88 on
5 Insert the Fiber Receiver card in slot 0 of the expansion cabinet or
chassis, as shown in Figure 89 on
6 Route the fiber-optic cable around the Cable Routing Guide as shown in
Figure 89 on page
Note: Be sure to wrap the cable a minimum of one complete loop
around the guide. This ensures sufficient cable for removing the Fiber
Receiver card later.
page
216.
End of Procedure
Small System
Page 213 of 562
page
216.
Installation and Configuration
215.