Chapter 14 - Installing And Connecting The Cross-Connect Terminal; General Information - Nortel Meridian 1 Planning, Installation And Operating Instructions

Chapter 14 – Installing and connecting
the cross-connect terminal

General information

Option 11C Compact
This chapter describes how to install and connect a typical cross-connect
terminal to a Meridian 1 Option 11C Compact system, using the BIX
cross-connect system. Although the use of the BIX system is not mandatory,
it is the recommended choice.
Information about the BIX cross-connect system is found in the following
publications:
• BIX In-Building Cross-Connect System Material Description
(NTP 631-4511-100)
• BIX In-Building Cross-Connect System Planning (NTP 631-4511-150)
• BIX In-Building Cross-Connect System Material Installation and
Servicing (NTP 631-4511-200)
Information about 1.5 Mb DTI/PRI related wiring and cables can be found in
the 1.5Mb DTI/PRI Administration and Maintenance Guide.
This chapter contains the following procedures:
• Procedure 12 "Installing the cross-connect terminal" on page 122
• Procedure 13 "Connecting the cables" on page 124
Planning, Installation, Fault Clearing and CCBR Guide
Page 121 of 536