Nortel Meridian 1 Succession 1000M Installation And Configuration Manual page 56

Page 56 of 562 Chassis system equipment
IP expansion
Fiber expansion
553-3011-210 Standard 1.00
For IP connectivity, four IP daughterboards are available:
• The NTDK83 dual-port 100BaseT
• The NTTK02 dual-port 100BaseF
• The NTDK99 single-port 100BaseT
• The NTTK01 single-port 100BaseF
For non-IP expansion, Fiber Expansion Daughterboards in the chassis and
Fiber Receiver cards in the expansion chassis allow for fiber connectivity
between the chassis and up to four fiber expansion chassis or cabinets.
Fiber Receiver card
Multi-chassis Small Systems require an NTDK23 Fiber Receiver card in each
additional chassis. The NTDK23 supports a 10 m (33 ft) plastic fiber-optic
cable. Each Fiber Receiver card provides one SDI port for remote TTY
access.
Fiber Expansion Daughterboard
Fiber Expansion Daughterboards must be installed on the NTDK20 SSC card
in order to connect to additional chassis. There are two kinds of Fiber
Expansion Daughterboards that can be matched with the NTDK23 Fiber
Receiver card:
• NTDK22 Single-port Fiber Expansion Daughterboard
• NTDK84 Dual-port Fiber Expansion Daughterboard
Both daughterboards are used with the A0632902 Fiber-optic (multi-mode)
cable.
Routing Guides
Each chassis in a multi-chassis system requires a Routing Guide, in order to
route and manage the fiber-optic cable. Only one guide is required in each
chassis.
October 2003