Nortel Meridian 1 Succession 1000M Installation And Configuration Manual page 295

Starting the Chassis system
Contents
Introduction
Startup procedures
This section contains information on the following topics:
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Startup procedures. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
This chapter describes how to start the Chassis system and how to make sure
that the system is operating correctly.
This chapter contains the following procedures:
• Procedure 47: "Startup procedure for a new system installation, using the
Small System Controller card" on
• Procedure 48: "Startup procedure for a previously installed system" on
page 297
Before you continue with the procedures described in this section, make sure
all necessary hardware is connected to or installed in the system. Check all
connections, and make sure that you have installed all of the circuit cards
correctly.
Before you start the system, complete Step 1 through Step 18 in "Installing
the Chassis system" on
page 296
page 107.
Small System
Page 295 of 562
Installation and Configuration
295
295