Miscellaneous Items - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

Page 42 of 562 Cabinet system equipment
Table 4
Cable and wire specifications (Part 3 of 3)
Cables and Wires
NTAK19 cable
A0601397 F-F DCE to DTE converter, or
A0601396 F-M DCE to DTE converter
NTBK04 1.5 Mb DTI/PRI carrier cable
(A0394216)
NTBK05CA coax cable
NTBK05DA twisted pair cable
NTAK10 2.0 Mb DTI cable
NTAK79 2.0 Mb PRI cable
NTAK50 2.0 Mb PRI cable
NE-A25B 25-pair cable
#6 AWG (#40 Metric Wire Gauge) insulated
ground wire
Cross-connecting wire

Miscellaneous items

553-3011-210 Standard 1.00
The following is a list of typical miscellaneous items that can be used as part
of the system installation. Quantities needed depend on the site and customer
requirements:
• QUA6 Power Failure Transfer Units (PFTU) to transfer lines during a
power or system failure
• NTBK80 grounding block
October 2003
Purpose / Description
SDI cable used with the NTAK02 and NTAK03
circuit cards.
May be required when connecting SDI ports to
TTYs, modems, etc.
Connects the NTAK09 1.5 Mb DTI/PRI card to
the Channel Service Unit (CSU). Brings Tx
and Rx pairs to a standard 5-pin connector.
Provides DTI/PRI connections.
Brings Tx and Rx pairs to a standard 5-pin
connector.
Connects peripheral equipment cards to
cross-connect terminals. NE-A25B connector
slots are located on the bottom of each
cabinet.
Connects a system cabinet to a building
ground source.
Makes cross-connections at the cross-connect
terminal.