Nortel Meridian 1 Succession 1000M Installation And Configuration Manual page 319

Procedure 50
Installing software for IP expansion, using the preprogrammed software
daughterboard
1 Power up the system, and the menu in step 2 appears.
BootP is a broadcast message used for IP Address discovery.
• For Point-to-Point installation, you must select Option 1.
• For Layer 2 LAN installation, the recommended selection is Option 1.
• For Layer 3 LAN installation, you must select Option 2.
2 Select Manual Configuration (option 2) from the IP Configuration Menu.
IP Configuration Menu:
1. Automatically Using BootP
2. Using Manual Configuration
3. Keep Existing Configuration
[q]uit, [p]revious, [m]ain menu, [h]elp or [?],
<CR> - redisplay
Enter Selection: 2 <CR>
3 Configure IP Expansion parameters.
The following sample IP parameters will be used in the menu example:
IP address of the expansion cabinet 100BaseT(F): 47.147.20.101
Subnet Mask of the expansion cabinet 100BaseT(F): 255.255.255.0
Gateway address: 47.147.20.1
IP address of the main cabinet 100BaseT(F): 47.147.10.100
The IP Parameters menu is displayed:
Enter Expansion New IP Parameters:
Expansion IP: 47.147.20.101
Expansion NetMask: 255.255.255.0
Main IP: 47.147.10.100
Expansion Router/Gateway: 47.147.20.1
Installing software
IMPORTANT!
Small System Installation and Configuration
Page 319 of 562