Nortel Meridian 1 Succession 1000M Installation And Configuration Manual page 96

Page 96 of 562 Installing the Cabinet system
Figure 24
Cable ends for 100BaseT IP connectivity
553-3011-210 Standard 1.00
NTDK8305 cable ends
8 Main power hook-up.
a. Connect the external power supply, if not already done.
If this system uses a commercial ac power supply, the power outlet
should be tested to make sure that the correct voltage is present
before plugging the power cord in the outlet.
If the system uses an external commercial ac power supply, plug the
ac power cord from each cabinet into the commercial ac power
supply outlet.
If the system uses a customer-provided dc power supply, plug the dc
power cord from each cabinet into the dc power source.
b. For ac-powered systems, set the circuit breaker on the NTDK70 or
NTDK78 ac/dc power supply in each cabinet to ON. For dc-powered
systems, set the circuit breaker on the NTAK28 circuit breaker
assembly for each cabinet to ON. Set the circuit breaker on the
NTDK72 dc power supply in each cabinet to ON.
October 2003