Nortel Meridian 1 Succession 1000M Installation And Configuration Manual page 290

Page 290 of 562
553-3011-210 Standard 1.00
Installing and connecting SDI and Ethernet ports
Figure 118
J7 Jumper Plug location on NTDK20EA SSC card
Procedure 45
Connecting the Ethernet cable to the Cabinet system
1 Insert the 50-pin end of the cable into the cable connector on the left side
of the retaining bar. See Figure 117 on
2 Route the cable through the fifth cable groove from the left side.
October 2003
Location of J7 jumper
plug connector
page 288.