Table of Contents
Advertisement
Page 30 of 184
i2002 Internet Telephone
First-time installation
IP address assignments
553-3001-368
Standard 1.00
During the first-time installation, there are IP address parameters that are
entered either manually or automatically depending on the installation
configuration. As well, you are prompted to enable or disable 802.1Q. For
more information, see "802.1Q description" on
There are three configuration modes you can choose from to obtain the IP
parameters. Review the following sections for more information on the
configuration mode that you are using.
Static IP address assignment
During the installation, the i2002 Internet Telephone parameters are entered
manually using the keypad.
Your System Administrator provides the following information: IP address,
subnet mask, and the default gateway.
You must also enter the Connect Server parameters including: IP address,
port number, action, and retry count.
Go to Procedure 2, "Installing an i2002 Internet Telephone for the first time"
on
page
31.
Dynamic IP address assignment — Partial DHCP
For a partial DHCP installation, you must provide, through the i2002 Internet
Telephone's keypad, the Connect Server parameters including: IP address,
port number, action, and retry count. Other parameters (Internet Telephone IP
address, subnet mask and default gateway) are retrieved from the DHCP
server.
The i2002 Internet Telephone password, node ID and TN must be entered
manually from the keypad.
For more information about DHCP servers, see Data Networking for Voice
over IP (553-3001-160).
October 2003
page
139.
Advertisement
Table of Contents
