A28 Fdd (Floppy Disk Drive) Removal; Tools Required; Procedure - Agilent Technologies E4991A Service Manual

A28 FDD (Floppy Disk Drive) Removal

Tools Required

• Pozidriv screwdriver, pt size #1 (small)
• Torx screwdriver, T15

Procedure

Step 1. Remove the outer cover as described in "Outer Cover Removal"
Step 1. Remove the front panel as described in "Front Panel Removal"
Step 2. Remove four screws fastening the side panel on the LCD side to the FDD folder.
Step 3. Remove four screws fastening the FDD folder to FDD.
Step 4. Remove the FDD from the FDD folder.
Step 5. Disconnect the mylar ribbon cable (item 5 in Figure 6-2 on page 236) at the FDD.
NOTE The mylar ribbon cable and their connector are fragile. You must be attentive as described
in NOTE on page 303 when you are instructed to disconnect or connect it.
Chapter 7
Replacement Procedure
A28 FDD (Floppy Disk Drive) Removal
291