Agilent Technologies E4991A Service Manual page 352

Messages
Permeability measurement mode only
The parameters have exceeded the number necessary for a command.
For example, when the program message "SWE:TYPE LIN,SEGM" is sent instead of the
proper program message "SWE:TYPE LIN", 2 parameters are sent even though only 1
parameter is required for this command. Therefore, the number of parameters is regarded
as invalid by the E4991A.
Refer to the command reference and check the number of parameters required.
73 Permeability measurement mode only
A command that is only valid for Magnetic Material Measurement Mode has been sent.
For example, in the Dielectric Measurement Mode, the CALC:FORM:PAR:MGA
command has been attempted in order to set the size of the magnetic substance.
Select Magnetic Material Measurement Mode.
72 Permittivity measurement mode only
A command that is only valid for Dielectric Measurement Mode has been sent. For
example, in the Magnetic Material Measurement Mode, the
SENS:CORR1:CKIT:STAN7:THIC command has been attempted in order to set the
thickness of the load standard for Dielectric Measurement.
Select Dielectric Measurement Mode.
22 Printer error
The printer has not responded to the control from the E4991A.
Confirm whether the printer's power is On or Off, the connection status of the cable, and
the paper supply.
-112 Program mnemonic too long
The length of a header has exceeded 12 characters. The length of a header here refers to the
length of the series of characters that are separated by colons (:).
Refer to IEEE488.2,7.6.4.1 for further details.
Q
-430 Query DEADLOCKED
This indicates a condition that has created a "DEADLOCK" Query error (refer to
IEEE488.2, 6.3.1.7). This error occurs, for example, when both input and output buffers
become full and when the E4991A is no longer able to carry out a process.
-400 Query error
The E4991A has found a Query error for which it is not able to specify the error message.
This code shows that a Query error defined in IEEE488.2, 11.5.1.1.7 or 6.3 has occurred.
-410 Query INTERRPUTED
This indicates a condition that has created an "INTERRUPTED" Query error (refer to
IEEE488.1, 6.3.2.3). This error is generated when, for example, the data byte "DAB" or
Get is received after the Query but before its response is fully sent.
-420 Query UNTERMINATED
This indicates a condition that has created an "UNTERMINATED" Query error (refer to
IEEE488.1, 6.3.3.2). This error occurs when the E4991A is designated as a talker (if
designated as a controller, data transmission is possible via the interface) and receives
352 Appendix E