Agilent Technologies E4991A Service Manual page 216

Troubleshooting
To Configure the A20 Digital Motherboard and BIOS (for serial prefix MY433
and later)
displayed as shown in Figure 4-50. If the setup is incorrect, select it using
and change the setting by pressing
If you want to exit from this page and return to main menu, press
Figure 4-50 Boot Menu
Change Supervisor Password
A password needs to be entered to execute the BIOS setup utility. If a password has not
been assigned in the E4991A, set the password using this BIOS setup utility as follows.
a. Select "Security" using
b. Select "Set Supervisor password" using
c. Enter the password of "e4991a" or "kid" depending on the default password set. Never
d. Press
e. If a message of "New supervisor password installed. Press any key to continue" is
Power Menu
The Power Menu shown below is displayed by choosing "Power" using
by pressing
displayed as shown in Figure 4-51. If "After Power Failure" is incorrect, select it using
If you want to exit from this page and return to main menu, press
216
key.
set another password.
key.
displayed, press key.
key at the BIOS Setup Utility main menu. The current setup states are
keys, and change the setting by pressing
keys.
keys at the BIOS Setup Utility main menu and press
keys and press
keys.
keys,
key.
key.
keys and
key.
Chapter 4