Agilent Technologies E4991A Service Manual page 32

Performance Test and Function Test
Performance Test
Figure 2-3 Power Level Accuracy Test Setup 1
2. Press
3. Set the E4991A as follows;
Setting
Frequency: 1MHz
Power: -15 dBm
4. Press
5. Select
6. Press
a. Press
b. Press
c. Press
d. Press
7. Press
8. Record the multimeter reading to the calculation sheet.
9. Calculate the test result according to the calculation sheet, then record it to the
performance test record.
10. Perform zeroing and calibrating the power meter
11. Connect the equipment as shown in Figure 2-4.
32
to preset the E4991A.
[Preset]
Operation
[start/stop]
[Source] - Osc Unit- Power
[Source] - Osc Level
.
[Trigger Setup]
Manual.
Trigger Source-
key ( - ) to initialize the 3458A, then Set it as follows;
[Reset] [blue] [->]
to set the measurement mode to AC voltage.
[ACV]
( -
[S] [blue] [N Rdgs/Trig]
 ,  ,  ,  to display SYNC, then press
- - -
[NPLC] [1] [0] [0]
to make a measurement.
[Trigger]
- -
Center [1]-[M/u]
-
[+/-]-[1]-[5]-[Enter]
),  ,  ,  to display SETACV.
[Enter]
-
[Enter]
Chapter 2