Procedure To Execute System Recovery (For Serial Number Other Than Jp1Kh Or A27 That Has Been Replaced) - Agilent Technologies E4991A Service Manual

A:\>
A:\> is indicated on the screen when the system recovery is complete.
Step 7. Shut down the E4991A by pressing the power switch.
Step 8. The E4991A will restart in the system recovery complete condition.
NOTE System recovery can be suspended without execution by pressing
A:\> is also indicated on the screen after this section is made. Remove the system recovery
disk and shut down the E4991A by pressing the power switch.
NOTE If you do not have the system recovery disk, you can make it by the following procedure.
1. Copy the files (copydisk.exe, recover.bin) which are downloadable from CTU-kobe
web site (internal) to specific directory on your PC.
2. Insert a floppy disk to the floppy disk drive in your PC.
3. Run the DOS prompt, and change the current directory to the specific directory which
includes the above two files.
4. Perform the following command. Then, the system recovery disk will be made
automatically.
" copydisk.exe recover.bin a: "
Procedure to execute system recovery (for serial number other than
JP1KH or A27 that has been replaced)
Step 1. Shut down the E4991A.
Step 2. Connect the external keyboard to the E4991A.
Step 3. Press the standby switch of the E4991A to turn it on.
Step 4. When the message in the figure below appears on the screen following the Agilent's logo
screen, immediately press
NOTE Watch the message carefully because after several seconds it will be replaced with the next
screen. Note that this is automatically done with no key operations.
Step 5. When "Recover Hard disk (C drive) [Y, N]?" is displayed, press
keyboard. If you want to quit the system recovery, press
usual.
Appendix B
System Installation for A27 Mass Storage
System Recovery (for serial prefix JP1KH, JP2KH, and MY432)
on the keyboard.
instead of Step 5.
[N] [Y]
on the
to start up the E4991A as
317