Agilent Technologies E4991A Service Manual page 151

Figure 3-25 System Backup Start Screen
Step 5. Press
Continue? [Y,N]? Y
A Backup file is already exist, Overwrite? [Y,N]? Y
Step 6. Remove the system backup disk from the floppy disk drive after confirming the following
display.
DONE
A:\>
A:\> is indicated on the screen when the system backup is complete.
NOTE
You can confirm if the system backup is complete by the following procedure.
A:\> C:
C:\> dir /a
Then, confirm the file size and the time stamp of the following two files.
1. drvspace.000
2. sysbak.dat (the same file size, and the time stamp is the present.)
Step 7. Shut down the E4991A by pressing the power switch.
Step 8. The E4991A will restart in the system backup complete condition.
NOTE System backup can be suspended without execution by pressing
A:\> is also indicated on the screen after this section is made. Remove the system backup
Chapter 3
System Backup (for serial prefix JP1KH, JP2KH, and MY432)
key on keyboard in the following case.
[Y]
Adjustment
instead of Step 5.
[N] [Y]
151