Agilent Technologies E4991A Service Manual page 336

Firmware Update
Firmware Update
Step 7. Remove the old version of the firmware using the following procedure.
1. Double-Click "E4991.msi" icon. The E4991A Setup Wizard(uninstall) will start
2. Click on the
3. Click on the
Figure C-3 E4991A Setup Wizard (uninstall)
Step 8. Install the new version of the firmware using the following procedure.
1. Double-Click "E4991.msi" icon. The E4991A Setup Wizard will start automatically as
2. Click on the
3. Click on the
4. After the disk1 installation is finished, insert the firmware installation disk2 (2 of 3)
5. After the disk2 installation is finished, insert the firmware installation disk3 (3 of 3)
6. Click on the
336
automatically as shown in Figure C-3.
Remove E4991A
Figure C-3, then click on the
to exit the "Installation Complete" window.
Close
shown in Figure C-4.
to continue the firmware installation on the E4991A Setup Wizard as
Next
shown in Figure C-4.
to start the firmware installation on "Confirm Installation" window.
Next
into the FDD of the E4991A, then click
into the FDD of the E4991A, then click
to exit on the "Installation Complete" window.
Close
option button on the E4991A Setup Wizard as shown in
button.
Finish
.
OK
OK
Appendix C