A2 Dc Bias Output Resistor/Conductance Adjustment (Opt 001 Only); Required Equipment; Procedure - Agilent Technologies E4991A Service Manual

Adjustment

A2 DC Bias Output Resistor/Conductance Adjustment (Opt 001 only)

A2 DC Bias Output Resistor/Conductance Adjustment (Opt
001 only)
The purpose of this procedure is to get the output resistor and the output conductance on
the A2 DC Bias Board.

Required Equipment

Calibration Kit

Procedure

Step 1. Run the adjustment program.
Step 2. Choose the A2 Adjustment(Opt.001) in the Spot Adjustment.
It is possible to perform this item with the All Adjustment too.
Step 3. Connect the instrument as shown in Figure 3-20 and Figure 3-21.
Figure 3-20 A2 DC Bias Output R/C Adjustment Setup (1/2)
146
Description
16195B(furnished with E4991A)
Recommended Model
Chapter 3