A28 Fdd (Floppy Disk Drive) Replacement; Tools Required; Removal Procedure; Replacement Procedure - Agilent Technologies ENA Series Service Manual

Replacement Procedure

A28 FDD (Floppy Disk Drive) Replacement

A28 FDD (Floppy Disk Drive) Replacement

Tools Required

•

Removal procedure

Refer to Figure 6-5 for this procedure.
Step 1. Remove the outer cover as described in "Outer Cover Removal" on page 166.
Step 2. Remove the front panel as described in "Front Panel Removal" on page 167.
Step 3. Disconnect the power supply cable from the FDD.
Step 4. Disconnect the flat cable from the FDD.
Step 5. Remove three TORX T20 screws (item 1) fastening the FDD assembly.
Step 6. Slide the A28 FDD assembly forward.
Step 7. Remove the four TORX T10 screws (item 2) fastening the FDD to the mount.
Replacement Procedure
Step 1. Fasten the angle to the new FDD, and then fasten it to the mount as shown in Figure 6-5.
Step 2. Reverse the order of the removal procedure.
Figure 6-5 A28 FDD Removal
172
TORX screwdriver, T10, T15, and T20
Chapter 6