Checking Pattern And Modifying - Okura Yusoki A Series Manual

3.6.

Checking pattern and Modifying

This section explains how to check the stacking pattern, side view of pattern, 3D
view pattern, enlarge the pattern on the display and over lap.
3.6.1. Stacking pattern
Planner (2D) stacking pattern will be displayed. By clicking "Up" or "Down" displaying
layer will be change.
3.6.2. Side view
The side viewing (2D) of stacking pattern are displayed. From this screen you can
sift the pattern by clicking "=>" or "<=." Select the shifting layer from "All layer" or
"Top layer only." Input shifting distance in Shift increment box. Shift the
Right/Left/Forward/Back with watching display. You can bring the pattern to the
center of the pallet by clicking the "Center" button on the display. This function use
for bring the over hanged pattern to inside of the operation range.
When you select the "Shifting the load fit for pallet edge. Not use shift increment"
then click the "=>" or "<=" products move to edge of pallet. PY mode pattern can
not move the stacking position.
3-11