Py Mode - Okura Yusoki A Series Manual

3.5.

PY mode

When stacking in a Pyramid shape (PY mode) for rice pallet, etc., the program is
created using the PY mode. When a program is created with this mode, the planar
position in each layer is automatically calculated so that the stacking pattern is like
Pyramid shape.
st
The "Base lay No." stacking position does not change. Setting range is from 1 layer
to actual quantity of layer. Pattern will be squeezed from selected planner layer to
top and expended from selected planner layer to bottom. Position calculation is done
by automatically.
The "Inclined" box is values for decreasing measurements of pallet width side. Input
st
the difference value of 1 layer outline dimension and top layer outline dimension.
After input the "Base lay No." and "Inclined", each planner layer's product positions
are calculated by automatically then planner display will be change. By click "cancel"
button, you can back to beginning.
The "Unmovable" box is set the fixed effective width. The center of this range calls
"Center of the pallet" and set this range by clicking "=>" or "<=" at last display
(each click moves 100mm).
Note
PY mode can not edit the stacking position
3-9