Calibrating System Components; Load Cal Factors - Agilent Technologies PSA Series Manual

Installation and Setup

Calibrating System Components

Calibrating System Components
Make sure you have connected, configured and verified the measurement system.
RF Power and Absolute Tuned RF Level measurements require Power Meter
NOTE
calibration with the Sensor Module. Calibration with each Sensor Module can
ensure the specified measurement accuracy.

Load Cal Factors

Step 1. Insert the floppy disk containing the Cal Factors of your sensor to the PSA floppy
disk drive.
Step 2. Press
Step 3. Press
Step 4. Press
Down Arrow
and the file will be loaded into the PSA.
You can edit the Cal Factors by pressing
to enter the config menu, then:
• press
highlight the data point you want to change to input your edits. See
Factors" on page
• press
• press
in the PSA; But you will have to restore the data by hand or as described in
Step 2 and 3 above;
• press
information in the PSA and will be loaded next time the PSA is powered on.
• press
a result of previously pressing
This feature is used if you incorrectly edited the Cal Factors or deleted all the
Cal Factors by mistake, and you need to restore the Cal Factors.
52
and select
MODE Measuring Receiver
, , ,
File Load Type Calibration Factor
, , ,
File Load Type Dir Select
to select the file name for your Sensor Module, then press
,
Cal Factors Edit Cal Factors
53.
,
Cal Factors Delete All Points
,
More Clear Power Sensor
Update Power-On Default
Recall Power-On Default
.
as the file type.
and select the A drive and use
, ,
System More More
and use and
Up Arrow
to delete all the Cal Factors;
to remove all Power Sensor information loaded
to save the current Sensor and Cal Factors
to load the Cal Factors file saved in the PSA, as
.
Update Power-On Default
and
Up Arrow
Load Now
,
Power Sensor Config
to
Down Arrow
"Edit Cal
Chapter 2