Agilent Technologies PSA Series Manual page 48

Installation and Setup
Setting up the System
11. Press
0.001dB or 0.01 dB.
Step 4. Perform system configurations for Sensor Module.
1. Load the Sensor Module Cal Factors. See
load the file CFDATA.XML to the PSA.
If you are using a power sensor that does not have a file or data disk containing
NOTE
calibration factors, you may need to input the calibration factors by hand. See
"Edit Cal Factors" on page
2. Press the
PS Config.
3. Once you have loaded the Cal Factors file, verify the Sensor Module
information, like Model No., Options, Serial No., Cal Date.
4. Press any key in this page to edit and change the parameter if necessary. Your
edits will be lost when the PSA power is shut down unless you press
Power-On Default
loaded by default next time the PSA is powered on.
5. You can press
displayed; or press
memory.
48
Power Meter Config, More, Resolution
53.
System, More, More, Power Sensor Config
to save. Once saved, the current file with your edits will be
,
More Clear Power Sensor
Recall Power-On Default
to select the resolution as
"Load Cal Factors" on page 52
keys to enter the menu of
to clear the Power Sensor information
to load the default file you saved in
to
Update
Chapter 2