Agilent Technologies PSA Series Manual page 257

Table 4-32 Audio AC Level Settings Window
Name
Detector Selection
Peak Hold
HP Filter
LP Filter
BP Filter
4.4.11.1 AMPLITUDE/Y Scale
The AMPLITUDE/Y Scale key accesses the menu to set the desired vertical scale and associated settings:
Default numbers are independent for each window.
4.4.11.1.1 Display Mode
If measurement results are to be displayed relative to a reference, enter the value as a ratio reference by selecting
RATIO.
Key Path:
Remote Command:
Preset:
State Saved:
Range:
Example:
4.4.11.1.2 Display Unit
Sets unit for Normal display mode.
Key Path:
Remote Command:
Preset:
State Saved:
Chapter 4
Corresponding Results
It can be RMS
It can be On or Off
It can be None, 50 Hz or 300 Hz
It can be None, 3 kHz, 15 kHz, 30 kHz or 300 kHz
It can be None or CCITT Weighing if PSA firmware
revision A.11.08 or above, or Option 23B is installed.
Amplitude/Y Scale
:DISPlay:AUDLevel:MODE NORMal|RATio
:DISPlay:AUDLevel:MODE?
NORMal
Saved in instrument state.
Normal | Ratio
:DISP:AUDL:MODE NORM
:DISP:AUDL:MODE?
Amplitude/Y Scale
:DISPlay:AUDLevel:UNIT V|MV|UV|DBV|DBMV|DBUV
:DISPlay:AUDLevel:UNIT?
V
Saved in instrument state.
Front-Panel Key and SCPI Command Reference
Measurement keys
257