System:psensor:clr - Agilent Technologies PSA Series Manual

Front-Panel Key and SCPI Command Reference
Front-Panel Keys
4.2.3.4 Clear Power Sensor
Clear all the information, including the cal factors, of the Power Sensor.
Mode:
Key Path:
Remote Command:
Remote Command Notes:
Example:
4.2.3.5 Delete All Points
Deletes all points.
Mode:
Key Path:
Remote Command:
Key Path:
Notes:
Example:
4.2.3.6 Edit Cal Factors
Accesses the editor that is used to show and edit the power sensor calibration factors.
4.2.3.6.1 Cal Factor
Sets the calibration factor of the current point.
Mode:
Key Path:
Preset:
State Saved:
Min:
Max:
138
MRECEIVE
System, Power Sensor Config, More

:SYSTem:PSENsor:CLR

Global to the current mode.
SYST:PSEN:CLR
MRECEIVE
System, Power Sensor Config, Cal Factor
:SYSTem:CFACtor:DALL
Mode Setup, Calibration, Power Sensor, Cal Factor Edit
There will be a pop up message to ask user to confirm deletion by pressing
this key again.
:SYSTem:CFAC:DALL
MRECEIVE
System, Power Sensor Config, Cal Factors, Cal Factor Edit
0.0
Saved in instrument state.
0.0
100.0
Chapter 4