Agilent Technologies PSA Series Manual page 241

4.4.8 Modulation Distortion Measurement
There is only one view available for Modulation Distortion measurement.
There are two windows in this view:
Modulation Distortion Numeric Results Window (upper)
•
Modulation Distortion Settings Window (lower)
•
Table 4-25 Modulation Distortion Numeric Results Window
Name
Modulation Distortion
Modulation Distortion
Ratio
Table 4-26 Modulation Distortion Settings Window
Name
IF BW Type
IF BW
Detector Selection
Peak Hold
HP Filter
LP Filter
De-emphasis Filter
Chapter 4
Corresponding Results
n=1,1st
Modulation Distortion
n=1, 2nd
This result will replace Modulation Distortion when
Display Mode is Ratio
Corresponding Results
It can be Auto, Manual or Min
This value is the IF bandwidth set manually
It can be Peak +, Peak −, Peak +/– 2 or RMS
It can be On or Off
It can be None, 50 Hz or 300 Hz
It can be None, 3 kHz, 15 kHz, 30 kHz or 300 kHz
It can be None, 25 us, 50 us, 75 us, or 750 us
Front-Panel Key and SCPI Command Reference
Measurement keys
241