Agilent Technologies PSA Series Manual page 253

4.4.10 Audio Frequency Measurement
There is only one view available for this measurement.
- Audio Frequency Numeric Results Window (upper)
•
- Audio Frequency Settings Window (lower)
•
Table 4-29 Audio Frequency Numeric Results Window
Name
Audio Frequency
Table 4-30 Audio Frequency Settings Window
Name
Ratio Reference
Ratio Mode
Detector Selection
Peak Hold
HP Filter
LP Filter
BP Filter
4.4.10.1 Amplitude/Y Scale
The AMPLITUDE/Y Scale key accesses the menu to set the desired vertical scale and associated settings:
Default numbers are independent for each window.
4.4.10.1.1 Display Mode
Sets the display mode.
Mode:
Key Path:
Remote Command:
Preset:
State Saved:
Range:
Dependencies/Couplings:
Chapter 4
Corresponding Results
n=1, 1st
Corresponding Results
It is the reference value for Ratio mode
It can be Log or Linear
It can be Peak +, Peak −, Peak +/– 2 or RMS
It can be On or Off
It can be None, 50 Hz or 300 Hz
It can be None, 3 kHz, 15 kHz, 30 kHz or 300 kHz
It can be None or CCITT Weighing if PSA firmware
revision A.11.08 or above, or Option 23B is installed.
MRECEIVE
Amplitude/Y Scale
:DISPlay:AUDFreq:MODE NORMal|RATio
:DISPlay:AUDFreq:MODE?
NORMal
Saved in instrument state.
Normal | Ratio
No
Front-Panel Key and SCPI Command Reference
Measurement keys
253