Agilent Technologies PSA Series Manual page 158

Front-Panel Key and SCPI Command Reference
Measure
4.3.3 RF Power
Allows the user to switch to the RF Power measurement.
Mode:
Key Path:
Remote Command:
Notes:
Example:
4.3.3.1 SCPI Remote Commands
:CONFigure:RFPower
:INITiate:RFPower
:FETCh:RFPower[n]?
:MEASure:RFPower[n]?
:READ:RFPower[n]?
Index: n Results Returned
<Mnemonic>
not specified or Returns the following 4 values:
n = 1
RF Power (dBm, Watt or Volt depending on the Display Unit setting)
RF Power
Reference RF Power (–999 in Normal mode, depends on Display Mode setting)
Relative RF Power (–999 in Normal mode, dB/%, depends on Ratio Mode setting)
RF Frequency (Hz)
Cal Factor (%, the Cal Factor is the value queried from the Cal Factor table according to the Carrier
Frequency)
158
MRECEIVE
Measure
:CONFigure:RFPower
This key invokes RF Power Measurement.
:CONF:RFP
Chapter 4