Agilent Technologies PSA Series Manual page 127

4.2.1.3 Low Pass Filter
Sets the type of low pass filters used by the instrument. The frequency indicated is the high frequency cut-off.
Mode:
Key Path:
Remote Command:
Preset:
State Saved:
Range:
Dependencies/Couplings:
Remote Command Notes:
Example:
4.2.1.4 Band Pass Filter
Selects the band pass filter. This function is only available when PSA firmware revision A.11.08 or above, or
Option 23B is installed.
Mode:
Key Path:
Remote Command:
Preset:
State Saved:
Range:
Dependencies/Couplings:
Remote Command Notes:
Example:
Chapter 4
MRECEIVE
Det/Demod
[:SENSe]:MRECeive:LPFilter OFF|F3K|F15K|F30K|F300K
[:SENSe]:MRECeive:LPFilter?
OFF
Saved in instrument state.
None (>300 kHz) | 3 kHz | 15 kHz | 30 kHz | 300 kHz
For Audio measurements, the 300 kHz choice is disabled, because the cutoff
frequency of FIR LP filter in FPGA of Audio HW is 275 kHz.
For Audio measurements the None (>300 kHz) key will be displayed as None.
Global to the current mode.
MREC:LPF F3K
MREC:LPF?
MRECEIVE
Det/Demod
[:SENSe]:MRECeive:BPFilter OFF|CCITt
[:SENSe]:MRECeive:BPFilter?
OFF
Saved in instrument state.
None | CCITT
None.
Global to the current mode.
MREC:BPF CCIT
MREC:BPF?
Front-Panel Key and SCPI Command Reference
Front-Panel Keys
127