N5531S System Requirements - Agilent Technologies PSA Series Manual

N5531S System Requirements

Table 2-1 PSA System Requirements
System Component
PSA with Options 233:
Measuring Receiver Personality
Additional options required to
enhanced performance
a. You can also select many other available PSA options. Contact your Agilent sales
office for information on options available for your instrument.
b. PSA Option 1DS and 110 are mutually exclusive. Option 110 covers the fre-
quency range of 10 MHz to the maximum frequency of the PSA. Option 1DS cov-
ers 100 kHz to 3 GHz.
Table 2-2 Power Meter System Requirements
System Component
P- Series Power Meter
EPM-P Series Power Meter
EPM Series Power Meter
a. You can use an Agilent EPM or EPM-P Power Meter with a LAN/GPIB Gateway.
Chapter 2
Model numbers supported
E4440A, E4443A, E4445A, E4446A, E4447A and E4448A
Firmware Revision A.09.18 or later (Firmware Version
A.11.11 or later when using the N5532B Sensor Module)
Option 123: mw/mmw preselector bypass above 3 GHz
a (Required for signals above 3 GHz, mutually exclusive with
Option AYZ)
Option 1DS: RF pre-amplifier below 3 GHz
(Highly recommended, mutually exclusive with Option 110)
Option 110: pre-amplifier
(Highly recommended, mutually exclusive with Option 1DS)
Option 107: audio input
(Required for Audio measurement)
Option N5531S-010: LAN connection kit incl. 1 hub and 3
LAN cables
Model numbers supported
N1911A or N1912A
a
N4416A or N4417A
a
N4418B or N4419B
Installation and Setup
N5531S System Requirements
Minimum Firmware when using
N5532B Sensor Module
A.05.02
A1.05.01/A2.05.01
A1.09.01/A2.09.01
b
41