Agilent Technologies PSA Series Manual page 149

4.2.6 Meas Control
These functions allow you to pause and resume the currently selected measurement and to select between
continuous or single measurements.
4.2.6.1 Measure
Press this key to toggle the measurement state between
different function than the
has reached the specified number of averages set by the average counter. When set to
will run continuously and execute averaging according to the current average mode, either repeat or exponential.
Key Path
Factory Preset
State Saved
Remote Command
Remote Command Notes
Example
4.2.6.2 Pause/Resume
Press this key to pause the current measurement until you reactivate the measurement. Once toggled, the label
of the key changes to read
Pause
the point at which it was paused.
Key Path:
Remote Command:
Chapter 4
front panel key. When set to
MEASURE
Meas Control
Cont
Saved in instrument state.
:INITiate:CONTinuous OFF|ON
When ON, at the completion of each trigger cycle, the trigger system
immediately initiates another trigger cycle.
When OFF, the trigger system remains in an "idle" state until
CONTinuous is set to ON or an :INITiate[:IMMediate] command is
received. On receiving the :INITiate[:IMMediate] command, it will go
through a single trigger cycle, and then return to the "idle" state.
The query INIT:CONT? returns 1 or 0. 1 is returned when the
instrument is continuous triggering. 0 is returned when it is single
triggering.
:INIT:CONT OFF
. The
Resume Resume
Meas Control
No equivalent command.
Front-Panel Key and SCPI Command Reference
and (continuous). NOTE: This key has a
Single Cont
, the measurement will continue until it
Single
key, once pressed, continues the active measurement from
Front-Panel Keys
, the measurement
Cont
149