Mode Setup - Agilent Technologies PSA Series Manual

Mode Setup

All measurements need to be set up in 3 steps: first at the Mode level, second at the
Measurement level, then finally the result display may be adjusted.
Press
Measuring Receiver
Press
external audio attenuation by pressing
value and unit. To change the audio input ranging, press
a range according to your input.
Press
Press
Frequency Counter
measurements.
Press
settings. The settings only apply to this measurement.
Press
Depending on the mode and measurement selected, some graphical and tabular
data presentations may be not available and
A setting may be reset at any time, and will be in effect on the next measurement
NOTE
cycle or View.
1. Select & set up a
Mode
2. Select & set up
a Measurement
3. Select & set up a
View of the Results
If you make changes to the UUT or measuring receiver settings after you make
CAUTION
your first measurement, press the
configuration.
Chapter 3
, then all licensed, installed Modes available are show. Press
MODE
to select Measuring Receiver mode.
to adjust the input port and attenuation. You can change the
Input/Output
key to adjust detectors, filters.
Det/Demod
to select a specific measurement to be performed. Press
MEASURE
or to get the RF frequency before making other
Preset
to make any adjustments as required to the selected measurement
Meas Setup
to select a display format for the current measurement data.
Trace/View
Step Primary Key
MODE
MEASURE
Trace/View
and entering the appropriate
Ext Aud Atten
Audio Ranging
or
X-Scale Y-Scale
Setup Keys
,
Mode Setup
,
Input/Output
,
Det/Demod
FREQUENCY Channel
Meas Setup
SPAN X Scale,
AMPLITUDE Y Scale
,
Next Window Zoom
key to optimize the measuring receiver
Restart
Making Measurements
Mode Setup
and select
may be grayed out.
Related Keys
System
,
Meas Control
Restart
,
File Save
,
65