Copper Testing Overview; Calibrating The Tester - Agilent Technologies WireScope 350 User Manual

8r…‡vs’vtÃ8‚ƒƒr…Ã8hiyvt
8‚ƒƒr…ÃU r†‡vtÃP‰r…‰vr

Copper Testing Overview

Calibrating the Tester

3−2
This chapter describes how to certify twisted-pair copper cabling. The
procedures in this chapter are sufficient for most copper certification
jobs. If the requirements of the job are not addressed here, refer to
Chapter 6, Expert Mode for Copper Testing.
Before you begin a test, the WireScope and DualRemote pair must be
calibrated. Calibration allows the WireScope to compensate for slight
anomalies in its measurement hardware or that of the companion
DualRemote unit.
1 Connect the WireScope 350 and DualRemote 350 in either of the
configurations shown below.
/LQN
&KDQQHO
3UREH
3UREH Q…rpv†v‚Ã8hyvi…h‡v‚
OR
/LQN
&KDQQHO
3UREH
3UREH
8hiyr