Drive Clutch Service; Drive Clutch Removal - Polaris RZR XP Service Manual

PVT SYSTEM

DRIVE CLUTCH SERVICE

DRIVE CLUTCH REMOVAL

1. Remove the three fasteners retaining the driver's side
rear shock guard.
q
2. Loosen the clamp
outer clutch cover.
3. Remove the nine screws
clutch cover.
4. Maneuver the outer clutch cover outward as shown
below to access the drive belt.
Angle the rear of the clutch cover up and use a slight
rocking motion to work the clutch free when removing
the cover. There will be very little clearance.
5. Mark the drive belt direction of rotation so that it can
be installed in the same direction.
5.6
retaining PVT inlet duct to the
w
that retain the outer
NOTE
6. Insert clutch spreader tool
and turn the tool clockwise to open the sheaves on
the driven clutch.
The driven clutch spreader tool is included with the
vehicle's tool kit
7. Walk the belt out of the driven clutch and drive clutch.
Remove the belt from the vehicle.
8. Hold the drive clutch using the drive clutch holding
tool and remove the drive clutch mounting bolt.
Drive Clutch Holding Tool:
PU-51861
9. Remove the drive clutch using the correct drive clutch
puller.
Drive Clutch Puller:
2872085
9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual
e
into the driven clutch
NOTE
© Copyright Polaris Industries Inc.