Dtc P0112: Intake Air Temperature Sensor Circuit Low - Suzuki Grand Vitara Service Manual

Hide thumbs Also See for Grand Vitara:
Table of Contents

Advertisement

1A-87 Engine General Information and Diagnosis:

DTC P0112: Intake Air Temperature Sensor Circuit Low

Wiring Diagram
Refer to "DTC P0111: Intake Air Temperature Circuit Range / Performance: ".
DTC Detecting Condition and Trouble Area
DTC detecting condition
DTC will be set when all of following conditions are detected for
0.5 seconds continuously.
• Engine is running
• Voltage of IAT sensor output is less than specified value
(High intake air temperature (low voltage / low resistance))
(1 driving cycle detection logic)
DTC Confirmation Procedure
1) With ignition switch turned OFF, connect scan tool.
2) Turn ON ignition switch and clear DTC using scan tool.
3) Start engine and run it for 10 sec.
4) Check DTC and pending DTC.
DTC Troubleshooting
NOTE
Before this trouble shooting is performed, read the precautions for DTC troubleshooting referring to
"Precautions For DTC Troubleshooting: ".
Step
1
Was "Engine and Emission Control System Check"
performed?
2
IAT sensor and its circuit check
1) Connect scan tool to DLC with ignition switch turned
OFF.
2) Turn ON ignition switch.
3) Check intake air temp. displayed on scan tool.
°
°
Is 119
C (246
F) indicated?
www.CarGarage.ir
Action
www.CarGarage.ir
Trouble area
• IAT sensor circuit
• IAT sensor
• ECM
Yes
Go to Step 2.
Go to Step 3.
S5JB0A1104024
No
Go to "Engine and
Emission Control
System Check: ".
Intermittent trouble.
Check for intermittent
referring to "Intermittent
and Poor Connection
Inspection: in Section
00".

Advertisement

Table of Contents
loading

Table of Contents