Rep 9.4 Cleaner Blade Kit - Xerox 8850 Service Manual

REP 9.4 Cleaner Blade Kit

NOTE: These are the instructions to install the Cleaner Blade Kit. The kit contains the following
items:
• Right-hand Seal (57 mm wide)
• Left-hand Seal (41 mm wide)
• Cleaner Blade
• Photoreceptor Seal
• Blade Retainer (3)
Switch off the Main Power Switch. Disconnect the Power Cord.
Removal
NOTE: In the following steps, the terms "Left" and "Right" describe machine locations as
observed when facing the Printer from the Roll Media Supply Drawer side of the Printer.
1. Remove the Drum Assembly (REP
2. (Figure 1): Remove the Photoreceptor Seal, Right-hand Seal, Left-hand Seal, Cleaner
Blade, and the three Blade Retainers from the Xerographic Module.
3. Use a vacuum cleaner to clean the channels and the areas where the new parts will be
installed.
8850/ 510DP
WARNING
9.2).
Right-hand Seal
Photoreceptor Seal
Photoreceptor
Seal Channel
Figure 1 Removing the Cleaner Blade
03/2003
4-63
Xerographic Module
Frame
Blade Retainer (3)
Cleaner Blade
Repairs and Adjustments
REP 9.4