Associating The Qs Ir Eye With A Grafik Eye ® Qs Control Unit - Lutron Electronics GRAFIK Eye QSGRN-6PCE Installation And Operation Manual

IR Setup
The QS IR Eye offers advanced programmable scene control depending on the IR remote being used.
Use the chart below to select the appropriate control mode on the GRAFIK Eye
IR Remote
GRX-IT
GRX-8IT
MIR-ITFS
C-FLRC
Third Party IR Remote
Associating the QS IR Eye with a GRAFIK Eye
Note: For use with Lutron remote models GRX-IT and GRX-8IT, or with
IR Eye
Change type?
1. Point the IR remote at the QS IR Eye. To enter programming mode, press and
hold the top and bottom buttons on the remote for 3 seconds until the LED on
Press OK
the QS IR Eye begins to flash slowly.
2. Press and hold the top scene button on the GRAFIK Eye
3 seconds. The scene LEDs will flash to confirm that the QS IR Eye has been
Change type?
associated. Press the OK button to continue.
3. Use the Master buttons to select "Scene" and press the OK button to accept.
Scene
4. Use the Master buttons to select one of the scene control types (listed below)
to correspond to the IR remote that will be used with the QS IR Eye. Press the
OK button to accept.
If "Default" was not selected, the info screen will prompt you to select which
Change type?
scene will correspond to the top button of the IR remote. Use the Master
buttons to select the desired scene, and press the OK button to accept. The
Default Scene
info screen will confirm that your settings have been saved.
Note: The "Default" scene control type will activate whichever scene command
5. Point the IR remote at the QS IR Eye. To exit programming mode, press and
hold the top and bottom buttons on the remote for 3 seconds.
Button Setup
First
1
Scene
Saved
Saved
®
1 9
Control Mode
4 Buttons & Off or 5 Buttons
8 Buttons & Off
Favorite or Zone control
Favorite or Zone control
Default
QS control unit:
®
third-party IR remotes.
is transmitted to the GRAFIK Eye
QS control unit:
®
2 10 3 11 4 12 5 13 6 14
QS control unit for
®
QS control unit.
®
GRAFIK Eye QS Control Unit Installation and Operation Guide 42
®
7 15 8 16
9-16
1-8
OK
GRX-IT
QS IR Eye
Master
buttons
OK
button
Press and
hold the
top scene
button
for 3
seconds to
associate
QS IR Eye
GRX-8IT
LED