Activate System Accessories; Faceplate Removal; Language Selection - Lutron Electronics GRAFIK Eye QSGRJ-3P Installation And Operation Manual

Activate System Accessories

Once your GRAFIK Eye QS control
®
unit is programmed, you will need to
activate any accessories or interfaces
that are a part of the system. Refer to the
instructions included with those devices
to set them up for proper communication
with the control unit.
®

Faceplate Removal

The faceplates may need to be removed
to change the color or to write in zone
labels. To remove either faceplate, open
it fully (flush to the wall), and pull up (for
the top faceplate) or down (for the bottom
faceplate) to pull the hinges out of their
slots.
Replace by sliding the hinges back into
their slots.
Pull up to remove
top faceplate
1 2 3 4 5 6
1 2 3 4
Pull down to
remove bottom
faceplate

Language Selection

The GRAFIK Eye
operating in the following languages:
• English
• French
• Spanish
• German
• Italian
To change the language to one of these
choices, press the Timeclock button
four times, until the "Language" screen
is displayed. (Note: Do not put the unit
in programming mode.) Use the Master
buttons to highlight your preferred
language, and press the OK button to
select and save.
OK
5 6
GRAFIK Eye QS Installation and Operation Guide 51
®
QS is capable of
®
Master
buttons
OK
OK
button
Timeclock
(back) button