Table of Contents
Advertisement
12
The Master
The Master is the place where all signals from the Groups are being mixed together and their
panorama position is set. Just like the Groups and Sounds, the Master can host up to four in-
sert effects.
12.1
The Master Properties
The Master Properties are organized into three sets: Mix, Groove, and Output Properties.
Here is a quick reminder on how to select and adjust Properties. For all details on how to dis-
play and adjust the Properties, please refer to section
↑4.4.2, Adjusting the
Properties.
Hardware
To display the desired Master Properties:
1.
Press
CONTROL
to enter Control mode.
2.
Press Button 1 to select MASTER.
3.
Make sure
MODULES
4.
Press Button 5 (MIX), Button 6 (GRV) or Button 8 (OUT) to select the Mix, Groove or Out-
put Properties, respectively.
The corresponding Properties are shown in the displays of your controller.
→
To adjust the displayed Properties:
1.
Press the dim lit Page buttons at the left of the displays to step through the various Pa-
rameter pages, if any. If all parameters are on a single Parameter page, both Page buttons
are off.
2.
Turn Knobs 1-8 to adjust the values of the parameters in the displayed page.
Software
To display the desired Master Properties:
(Button 4) is deactivated to show the Master Properties.
↑4.4.1, Selecting a Set of Properties
MASCHINE MIKRO MK2 - Manual - 315
The Master
The Master Properties
and
Advertisement
Table of Contents
