Selecting A Loop Range - Native Instruments MASCHINE MIKRO MK2 Manual

The Scene Position marker underneath the Scene slot.
10.4.2

Selecting a Loop Range

The basic rule is: A single selected Scene is always looping automatically.
But MASCHINE also allows you to select several consecutive Scenes and play them one after
the other in a loop. Here is how to select the desired range of Scenes.
Hardware
On your controller:
1. Press and hold SCENE
2. Press and hold the pad corresponding to the start Scene.
3. While holding the first pad, press the pad corresponding to the end Scene.
The start and end Scenes along with all Scenes in-between are played one after the other
→
in a loop. On your controller, the pads corresponding to all these Scenes are fully lit to
indicate the loop range.
You can also quickly select all Scenes in one go:
Press SCENE + Button 2 (ALL) to include all available Scenes in the loop.
►
Software
The Arranger provides a timeline located under the slot labels that always show the current
loop range:
The Arranger timeline showing that the single Scene Pt A is looped.
To select another loop range:
to enter Scene mode (or pin it by pressing
Creating a Song using Scenes
SCENE + Button 1).
MASCHINE MIKRO MK2 - Manual - 273
Playing with Scenes