Native Instruments MASCHINE MIKRO MK2 Manual page 98

Sampler parameters – page 4 of 6: Modulation Envelope and Destination in the software.
Modulation Envelope
The Modulation Envelope
"modulate") specific Sampler parameters according to the way you play on the pads. Its pa-
rameters are matched to those of the
1: Voice Settings and Engine), so that you have either an ADSR (Attack, Decay, Sustain, Re-
lease) envelope or an AHD (Attack, Hold, Decay) envelope to modulate your parameters. If you
choose Oneshot mode, only the AHD envelope (pictured) will be available for modulation.
Envelope Controls
Attack
Hold
Decay
Sustain
Release
Destination
This is where you define modulation targets for the Modulation Envelope, i.e. the parameters
you want this envelope to control. The knobs adjust the amount of modulation for the following
targets:
Parameter
Pitch
Cutoff
section offers an additional envelope allowing to further modify (or
Amplitude Envelope
Description
The time it takes for the envelope to reach its maximum level.
How long the envelope will stay at its maximum level.
With Decay you adjust how fast the envelope drops to the sustain level in ADSR
mode; in AHD mode it is used to adjust how fast the envelope fades out.
The envelope level that will be maintained as long as the note is played.
The time for the sustain level to return to zero after the note has ended.
Modulation Destination
Tune parameter of the Pitch / Gate
Cutoff parameter of the Filter
page 3.
section on page 2 (see
section on page 2.
section (with filter types LP2, HP2, BP2 only) on
MASCHINE MIKRO MK2 - Manual - 98
Working with Sounds
The Sampler Module
↑4.2.1, Page