Native Instruments MASCHINE MIKRO MK2 Manual page 259

The signal of each auxiliary output is taken by default after the main output level control
has been applied. This can be changed on the second page of the Output Properties. For a
detailed description of the Output Properties, please refer to
(for Sounds) and
You can repeat the process to route more Sounds/Groups to the same send effect, or route the
same Sound/Group to another send effect send using
Software
1. If you want to route a Group's output to the send effect, click the desired Group slot in
the Arranger and click the
2. If you want to route a Sounds' output to the send effect, click the Group slot of the Group
containing that Sound in the Arranger, click the desired Sound slot in the Pattern Editor,
and click the SOUND
3. Click OUT in the Properties selector at the bottom left of the Control area to display the
Output Properties (in the example underneath we show the Output Properties of a Sound).
4. In the Aux 1 or Aux 2
configured as send effect which you want to send the audio to. In addition to the usual
entries available in both menus, you will find all the Sounds you have configured as send
effects. For each of them, the entry shows the Group letter followed by the Sound name
(in the example underneath we select the entry D: Reverb for the
↑5.1, The Group Properties
GROUP tab in the Control area.
tab in the Control area.
section on the right, click the
↑4.4, The Sound Properties
(for Groups).
AUX 2.
Output selector and select the Sound
Aux 1
MASCHINE MIKRO MK2 - Manual - 259
Using Effects
Creating a Send Effect
output)