Native Instruments MASCHINE MIKRO MK2 Manual page 288

Preparing the Slices
The SLICE page on the controller.
Parameter
MODE
SLICES
(Split mode only)
LENGTH
(Grid mode only)
SENS
(Detect mode only)
TEMPO
BPM
EDIT
Edit Mode
In Edit mode you can select and fine-tune each particular Slice.
On the SLICE page of the Sampling mode, press Button 5 (EDIT) to enter Edit mode.
►
Description
Using Knob 1, you can select either SPLIT,
SPLIT: In Split mode, the Sample will be sliced into equally spread Slices.
GRID: In Grid mode, the Sample will be sliced according to note values.
DETECT: In Detect mode, the Sample will be sliced according to its transients.
The following parameter will vary according to the selected mode.
Here you can choose how many Slices you want the Sample to be split into: 4,
8, 16 or 32.
Select the note value using Knob 2: available lengths are 4th, 8th, 16th and
32nd notes.
Sensitivity parameter for the transient recognition (Knob 2). Higher values will
cause more Slices to be detected because more transients will be recognized,
lower values will result in less slices. This parameter should be adjusted until all
the musically significant slices are being detected in the right display.
Determines the tempo of the Sample: available options are
Shows the tempo based on the
you can dial in a tempo value using Knob 4; if
from multiples of the tempo calculated by MASCHINE.
You can edit separate Slices using the Edit mode. Press Button 5 to enter Edit
mode (see paragraph below).
Controlling Sampling from the Hardware
GRID or DETECT.
TEMPO parameter above; if
AUTO is selected, you can choose
MASCHINE MIKRO MK2 - Manual - 288
Sampling and Sample Mapping
AUTO and MANUAL.
MANUAL is selected,