Slicing A Sample (Software) - Native Instruments MASCHINE MIKRO MK2 Manual

In Beat mode, if you set a target tempo that is smaller than a tenth of the original tempo,
all parameter will turn to red and the
tempo to enable the
Once you have set the parameters to the desired values, click
►
shifting and/or time stretching to the selected region in the Sample, or
Sample untouched.
11.2.3

Slicing a Sample (Software)

Slicing allows you to chop up loops to be able to extract single Sounds (the drum sounds of a
drum loop for example), but is also good for preparing a loop to be played back at another than
the original tempo without changing its pitch or timing.
If your Sound contains more than one Sample, all your actions in the
fect the Sample of the Zone currently selected in the
Sample (Software)
You can see that your loop now has a couple of equally spread vertical lines in the wave-
→
form: this is where the Slices are going to be applied (i.e. cut).
You can select and listen to individual Slices by clicking on their waveform.
APPLY
APPLY button again!
for more info on selecting Zones in the
button will be disabled. Set a higher target
APPLY to apply the pitch
SLICE
MAP page! See ↑11.2.4, Mapping a
MAP page.
MASCHINE MIKRO MK2 - Manual - 303
Sampling and Sample Mapping
Controlling Sampling from the Software
CLOSE to let the
page will af-